9-93
Command Line Reference
Ethernet Interface Commands
Command Usage
This command allows you to disable the Ethernet interface due to
abnormal behavior (e.g., excessive collisions), and re-enable it after the
problem has been resolved. You may also want to disable the Ethernet
interface for security reasons.
Example:
description
This command specifies a human-readable string description of this interface.
Syntax
description <string>
• string - The alphabetical description of the interface.
(Maximum characters 1-255)
Default Setting
None
Command Mode
Ethernet Interface Configuration
Example
dns primary
This command establishes the primary DNS server address. The no version of
the command clears the primary IP address, if one is set and does not require
for the IP to be specified.
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# disable
Connection to the host is lost.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# description Ethernet
ProCurve Access Point 530(ethernet)#
To Next Page
Loading...
Need help?
General
