7-35
Wireless Security Configuration
Configuring RADIUS Client Authentication
4. Enter the maximum number of retransmission attempts to be made in the
Retransmit Attempts field.
5. Select Internal Server to establish the internal server parameters as the
RADIUS server. If selected, proceed to step 8. If not selected, continue to
steps 4–8.
6. For the primary RADIUS server, type the IP address in the Radius IP field.
7. In the Port field, specify the UDP port number used by the RADIUS server.
8. In the Key field, specify the shared text string that is also used by the
RADIUS server.
9. (Optional) If you need to configure a secondary RADIUS server in the
network, specify its IP address and other parameters in the appropriate
fields. Otherwise, leave the IP address as all zeros (0.0.0.0).
10. Select Internal Server as failover to ensure that RADIUS authentication
remains uninterrupted if the primary server disconnects.
11. Select [Update] to set the RADIUS servers for RADIUS authentication.
CLI: Setting RADIUS Server Parameters
CLI Commands Used in This Section
The following example shows how to configure RADIUS authentication
failover and the RADIUS retransmit retry parameter for this WLAN.
Command Syntax CLI Reference Page
[no] radius failover-to-local | retransmit 9-66
[no] radius <primary | secondary> 9-67
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)#radius failover-to-
local
ProCurve Access Point 530(radio1-wlan1)#radius retransmit 30
To Next Page
Loading...
Need help?
General
