HP 530 - Show Lldp

9-49
Command Line Reference
Network Management Application Commands
Example
show lldp
This command displays the status of the Link Layer Discovery Protocol
(LLDP) service on the device.
Syntax
show lldp
Default
N/A
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# lldp
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# show lldp
LLDP Status Enabled
ProCurve Access Point 530(config)#