HP 530 - Page 323

9-15
Command Line Reference
General Commands
• custom-default -Shows custom default configuration file of device. See
“show custom-default” on page 9-58.
• debug - Shows debug-related information on this device. See “show
debug” on page 9-33.
• detected-ap - Shows detected neighboring wireless network details.
See
“show detected-ap” on page 9-140.
• filters - Shows settings for traffic/security filters on this device. See
“show filters” on page 9-89.
• interfaces - Shows information about the interfaces on this device. See
“show interface” on page 9-98.
• ip - Shows the current IP configuration on this device. See “show ip” on
page 9-97.
• lldp - Shows Link Layer Discovery Protocol (LLDP) details. See “show
lldp” on page 9-49.
• logging - Shows all the entries in the event log. See “show logging” on
page 9-33.
• mac-auth-local - Show all the entries in the local MAC address authen-
tication control lists. See
“show mac-auth-local” on page 9-74.
• qos - Shows QoS details on this device and wireless system. See “show
qos” on page 9-156.
• radios - Shows information about the radio(s) on this device. See “show
radio” on page 9-117.
• radius-local - Shows status of the internal RADIUS server on device.
See
“show radius-local” on page 9-70.
• running-config - Shows the running configuration file of this device.
See
“show running-config” on page 9-60.
• snmp-server - Shows SNMP community and trap information. See
“show snmp-server” on page 9-45.
• sntp - Shows configured time protocol and servers on this device. See
“show sntp” on page 9-36.
• ssh - Shows SSH configuration and the status of active connections.
See
“show ssh” on page 9-27.
• ssid - Shows SSID information on this device or radio context. See
“show ssid” on page 9-118.
• stations - Show associated wireless station details. See “show stations”
on page 9-123.
• supported-rate - Show information about supported transmission rates
on this device. See
“show supported-rate” on page 9-124.