9-121
Command Line Reference
Wireless Interface Commands
Example: show wlans
ProCurve Access Point 530(radio1-wlan1)# show wlans
All WLANs on Radio 1:
# WLAN BSSID VLAN Security Status
------------------------------------------------------------------------------
1 SSID 1 00:14:C2:A5:22:E0 1 (U) No Sec. Enabled
2 SSID 2 not assigned yet none(-) No Sec. Disabled
3 SSID 3 not assigned yet none(-) No Sec. Disabled
4 SSID 4 not assigned yet none(-) No Sec. Disabled
5 SSID 5 not assigned yet none(-) No Sec. Disabled
6 SSID 6 not assigned yet none(-) No Sec. Disabled
7 SSID 7 not assigned yet none(-) No Sec. Disabled
8 SSID 8 not assigned yet none(-) No Sec. Disabled
9 SSID 9 not assigned yet none(-) No Sec. Disabled
10 SSID 10 not assigned yet none(-) No Sec. Disabled
11 SSID 11 not assigned yet none(-) No Sec. Disabled
12 SSID 12 not assigned yet none(-) No Sec. Disabled
13 SSID 13 not assigned yet none(-) No Sec. Disabled
14 SSID 14 not assigned yet none(-) No Sec. Disabled
15 SSID 15 not assigned yet none(-) No Sec. Disabled
16 SSID 16 not assigned yet none(-) No Sec. Disabled
All WLANs on Radio 2:
# WLAN BSSID VLAN Security Status
------------------------------------------------------------------------------
1 SSID 1 00:14:C2:A5:22:F0 1 (U) WPA-.1X Enabled
-- MORE --, next page: Space, next line: Enter, quit: Control-C
To Next Page
Loading...
