3-12
Using the Command Line Interface (CLI)
Using the CLI
Typing ? at the Global Configuration level produces this listing:
Figure 3-4. Example of the Configuration-Level Command Listing (Partial Listing)
ProCurve Access Point 530(config)# ?
ap-authentication Configure username/password this access point uses to au
thenticate to the network.
buttons Enable/disable the ability to clear the password(s) and/
or configuration(s) via the buttons on this device.
cli-confirmation Enable/disable all confirmation dialogs for all CLI inte
rfaces on this device.
console Enable/disable the serial console on this device.
copy Copy data and configuration files to/from this device.
country Set the country code for the IEEE 802.11d regulatory dom
ain support.
deauth-mac Enter MAC address to de-authenticate from this device.
dns Configure DNS parameters.
domain Set the system domain name suffix to use when a domain n
ame suffix is not obtained through DHCP.
end Return to the Manager level context.
erase Erase stored files.
exit Return to the previous context or terminate current cons
ole/telnet session if you are in the Manager context lev
el.
group-config Add to a group, remove from a group, or re-configure gro
up-config settings.
hostname Set the system hostname.
inter-station-blockingEnable/disable blocking of direct communication between
wireless stations on this device.
interface Enter the Interface Configuration level context for the
specified interface.
lldp Enable/disable the Link Layer Discovery Protocol (LLDP)
service on this device.
lockout-mac Add or remove MAC addresses to be locked out of this dev
ice.
logging Configure logging/syslog-related settings for this devic
e.
logout Terminate this session.
mac-auth-local Add/remove local MAC address authentication control list
s entries on this device.
page Toggle paging mode.
password Configure local passwords.
ping Send ICMP Ping requests to a device on the network.
radio Enter the Radio Configuration level context for a specif
ic radio.
radius-local Configure user accounts for the internal RADIUS server o
n this device.
....