4-25
Using the ProCurve Web Browser Interface
Tasks for Your First ProCurve Web Browser Interface Session
Note If you want security beyond that achieved with user names and passwords,
you can disable access to the either the or the CLI and limit management
access to, for example, only the Web browser interface, only the CLI via the
console port, Telnet, or SSH. For more information, see
“Web: Configuring Access
Controls” on page 5-10
Figure 4-14. Setting the Management Password
To Set the Management Password:
1. Click Management > AP Access and select the Password tab.
2. In the New Password field, enter a new password.
3. In the Confirm Password field, re-enter the new password.
4. Click [Update] to activate the new password.
Notes ■ The password is case sensitive and must be at least 1 character and at
most 32 characters long. However, only the first 8 characters of the
password are used; character number 9 and above are ignored at log in.
■ The password you assign in the Web browser interface will overwrite the
previous settings assigned in either the Web browser interface or the
access point console. That is, the most recently assigned user password
is immediately effective for the access point, regardless of which interface
was used to assign these parameters.
To Next Page
Loading...
Need help?
General
