4-30
Using the ProCurve Web Browser Interface
Tasks for Your First ProCurve Web Browser Interface Session
To Set IP Parameters i:
1. Select Network Setup > Ethernet.
2. To set a dynamic connection, select DHCP in the Connection Type drop-
down.
3. To set a manual connection, select Static IP in the Connection Type drop-
down.
4. If you chose Static IP, enter the IP address and the subnet mask in the Static
IP Address and Subnet Mask fields. The defaults automatically populate.
5. If a management station exists on another network segment, in the Default
Gateway field enter the IP address of a gateway that can route traffic
between these segments.
6. Enter the IP address for the primary and secondary DNS servers to be used
for host-name to IP address resolution.
7. Optionally enter the domain suffix for hostname/domain-name lookups
in the Domain field.
8. Click
[Update] to save these IP settings.
Note If you change the IP address using the Web interface, you must log in again
using the new address.
To Next Page
Loading...
Need help?
General
