B_configure.doc 127 Tue Jul 2 15:27:17 1996
127
Changing Your Workstation’s Hardware Configuration
Installing Additional memory
6 Replace the main tray assembly as described in “Replacing the Main Tray As-
sembly,” earlier in this appendix.
To verify that this installation was successful, follow the steps in Appendix
D, “The Boot Console Interface,” on displaying memory information. If you
have only replaced a faulty memory module, you must issue the pdt clear
command in the service menu of the Boot Console Interface. Answer yes (y)
to the prompt “Continue? (Y/N) >.”
To Next Page
Loading...
