B_configure.doc 140 Tue Jul 2 15:27:17 1996
140
Changing Your Workstation’s Hardware Configuration
Installing an EISA, PCI, or GSC Option Board
Installing the Option Board
Follow these steps to install a GSC, EISA, or PCI board into your worksta-
tion:
1 Remove the main tray assembly as described in “Removing the Main Tray As-
sembly” earlier in this appendix.
2 Press the fan release clip and rotate the fan, as shown in Figure 52.
Figure 52 Rotating the Fan
3 Remove the screw from the EISA retainer, and remove the EISA retainer, as
shown in Figure 53.
Figure 53 Removing the EISA Retainer
EISA Retainer
To Next Page
Loading...
