C_scsi.doc 162 Tue Jul 2 14:56:06 1996
162
SCSI Connections
Assigning SCSI Device IDs
5 Write in the SCSI device ID of any internal drives in Table 26.
6 Write in the type of external single-ended drives currently connected to your
workstation under the heading “External Device Drives” and each drive’s SCSI
device ID under the heading “Device ID.”
7 Add your new drive to the table if it is an external device. If it is an internal drive,
continue to Step 8.
NOTICE: The C1700A Magneto-Optical Autochanger uses three SCSI IDs, and
accounts for three of the seven devices allowed on the SCSI bus.
Table 26 Single-Ended SCSI Device IDs
SCSI Device Drives
Device ID (Address) Number
(Only 0 through 6 Available)
Internal External
Internal System Drives:
System SCSI Drive(s)
CD-ROM Drive (if present, uses ID No.2) __________ N/A
4-mm DDS Tape Drive
(if present, uses ID No.1)
__________ N/A
External Device Drives N/A __________
1st External Device __________________ N/A __________
2nd External Device __________________ N/A __________
3rd External Device __________________ N/A __________
4th External Device __________________ N/A __________
5th External Device __________________ N/A __________
6th External Device __________________ N/A __________
7th External Device __________________ N/A __________
NOTICE: You can have no more than 7 single-ended SCSI devices (internal and ex-
ternal) connected to the system.
To Next Page
Loading...
