D_boot_cons.doc 178 Tue Jul 2 10:44:54 1996
178
The Boot Console Interface
Displaying and Setting Paths
The paths are displayed in Mnemonic Style Notation, as shown in Table 29.
To display the current setting for a particular system path, follow the direc-
tions in “Accessing the Boot Console Interface” earlier in this appendix, and
then type the following at the prompt:
Main Menu: Enter command > path path_type
where path_type is one of the path types listed in Table 28.
For example, to get the path to the primary boot device, follow the directions
in “Accessing the Boot Console Interface” earlier in this chapter, and then
type the following at the prompt:
Main Menu: Enter command > path primary
To set a system path to a new value, follow the directions in “Accessing the
Boot Console Interface” earlier in this chapter, and then type the following
at the prompt:
Main Menu: Enter command > path path_type path
where path_type is one of the path types listed in Table 28 and path is the
specification of the path in Mnemonic Style Notation (as described in Table
29). For example, to set the primary boot path to a SCSI disk with an ID of
6.0, follow the directions in “Accessing the Boot Console Interface” earlier
in this appendix, and then type the following at the prompt:
Main Menu: Enter command > path pri sescsi.6.0
Table 29 Mnemonic Style Notation
I/O Type Specification Format
Built-in FWSCSI fwsci.scsi_address.logical_unit_number
Built-in SCSI sescsi.scsi_address.logical_unit_number
Optional gscn.scsi_address.logical_unit_number
Built-in LAN lan.server_address.init_timeout.io_timeout
To Next Page
Loading...
