SAS RAID 0 configuration
Follow the steps below to configure an Integrated Striped (IS) volume with the BIOS-based configuration
utility. The configuration procedure assumes that the system already has the required disk and disk
controllers.
1. On the Main menu screen of the BIOS-based configuration utility, use the arrow keys to select an
adapter.
2. Press Enter to go to the Adapter Properties screen.
3. On the Adapter Properties screen, use the arrow keys to select RAID Properties.
4. Press Enter to go to the RAID Properties screen.
5. In the RAID Properties screen, use the arrow keys to select the first disk for the IS volume. Then
use the arrow keys to move to the Array Disk column for this disk, and press the SPACE, +, or -
key to select Yes as the value for this column. If partitions are defined on the selected disk, a
message appears warning you that data on the disk will be lost when the striped volume is created.
Press the M key to migrate, or the D key to delete the data on the drive.
6. Repeat the previous step to select up to three more disks for the striped volume.
7. Press the C key to create the array once all drives have been chosen, then press Esc and
select Save.
ENWW SAS RAID 0 configuration 145
To Next Page
Loading...
Need help?
General
