Figure 4-15 Removing the power supply
To replace the power supply, reverse the previous steps.
System fan assembly
To remove the system fan assembly:
1. Disconnect power from the system (
Predisassembly procedures on page 60) and remove the side
access panel (
Side access panel on page 66).
2. Disconnect the fan plug 1 from the system board. .
3. Remove the four screws 2 from the rear of the chassis with a Phillips screwdriver, and lift it 3 out
of the chassis.
Figure 4-16 Removing the system fan
To replace the system fan assembly, reverse the previous steps.
ENWW Steps for removal and replacement of components 73
To Next Page
Loading...
