Copying to a single workstation
CAUTION A setup configuration is model-specific. File system corruption can result if source
and target workstations are not the same model. For example, do not copy the setup configuration
from an HP xw4200 Workstation to an HP xw4400 Workstation.
1. Select a setup configuration to copy, and reboot the workstation.
2. As soon as the workstation powers on, press and hold the F10 key until you enter the Computer
Setup (F10) Utility. Press Enter to bypass the title screen, if necessary.
NOTE If you do not press the F10 key at the appropriate time, you must restart the
workstation and press and hold the F10 key again to access the utility.
If you are using a PS/2 keyboard, you may see a Keyboard Error message—disregard it.
3. If you are using a diskette or other storage device, insert it now. If not, proceed.
4. Click File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen
to create the configuration diskette.
5. Power off the workstation to be configured and insert the configuration diskette.
6. Power on the workstation to be configured.
7. Press and hold the F10 key until you enter the Computer Setup (F10) Utility. Press Enter to bypass
the title screen, if necessary.
8. Click File>Replicated Setup>Restore from Removable Media, and follow the instructions on the
screen.
9. Restart the workstation when the configuration is complete.
Copying to multiple workstations
CAUTION A setup configuration is model-specific. File system corruption can result if source
and target workstations are not the same model. For example, do not copy the setup configuration
from an HP xw4200 Workstation to an HP xw4400 Workstation.
This method takes a little longer to prepare the configuration diskette, but copying the configuration to
target workstations is significantly faster.
NOTE A bootable diskette is required for this procedure. If Windows XP is not available to use
to create a bootable diskette, use the method for copying to a single workstation instead (see
Copying to a single workstation on page 39
1. Create a bootable diskette.
2. Select a setup configuration to copy.
3. Restart the workstation.
4. As soon as the workstation powers on, press and hold the F10 key until you enter the Computer
Setup (F10) Utility. Press Enter to bypass the title screen, if necessary.
ENWW Desktop management 39
To Next Page
Loading...
Need help?
General
