7. Connect the hard drive LED cable from the card to the hard drive LED connector on the system
board. You can find the location of this connector on the illustration on the inside of the side access
panel.
Figure 4-46 Connecting the SAS cable to the hard drive
SATA hard drive
For more information on SATA hard drives and the SATA RAID configurations, refer to the SATA devices
appendix.
To remove a hard drive:
1. Disconnect power from the system (
Predisassembly procedures on page 60) and remove the side
access panel (
Side access panel on page 66).
2. Disconnect the data 1 and power 2 cables from the hard drive.
Figure 4-47 Removing the hard drive
94 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
