CAUTION:
To avoid damage to the processor, verify that the plastic tabs on the processor are pulled fully out
before installation.
CAUTION:
To avoid damage to the processor, handle the processor only by the edges. Do not touch the bottom
of the processor, especially the contact area.
CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor configurations
must contain processors with the same part number.
CAUTION:
To prevent thermal instability and damage to the server, do not separate the processor from the
heat sink after assembling.
The processor and heat sink ship as separate units and are coupled during installation into the server.
Procedure
1. Open the processor cage.
2. Remove the processor airflow baffle.
70 Optional components
To Next Page
Loading...
Need help?
General