5. Hewlett Packard Enterprise is not liable for blocked data access caused by improper TPM use. For
operating instructions, see the encryption technology feature documentation provided by the operating
system.
To install a TPM:
• Power off the server.
◦ Shut down the OS as directed by the OS documentation.
◦ Press the Power On/Standby button to place the server in standby mode.
When the server enters standby power mode, the system power LED changes to amber.
◦ Disconnect the power cords to the server.
• Extend the server from the rack, or remove the server from the pedestal kit, and place it on an anti-
static pad.
• Remove the top access panel.
• Disconnect any cables that might prevent access to the TPM connector.
• Install the TPM board. Press down on the connector to seat the board.
• Install any options or cables previously removed to access the TPM connector.
• Install the access panel.
• Install the server in the rack or replace the server in the pedestal kit.
• Power up the server.
◦ Connect the power cords.
◦ Press the power button.
To enable the TPM:
• Boot to the UEFI menu.
• Enter the secconfig tpm on command.
Optional components 77
To Next Page
Loading...
Need help?
General