HPE ProLiant Gen9

Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Server Availability > ASR Timeout and press Enter.
2. Select a setting and press Enter.
a. 5 Minutes
b. 10 Minutes
c. 15 Minutes
d. 20 Minutes
e. 30 Minutes
3. Press F10.
Wake-On LAN
Use this option to enable or disable the ability of the server to power on remotely when it receives a special
packet. When enabled, Wake-On LAN powers up the system remotely using a WOL-capable NIC. This option
requires a WOL-capable NIC, NIC driver, and operating system.
NOTE:
If you enable this option, remove all power cords before adding or removing any adapters. Some adapters
can cause the system to power on when added or removed.
Enabling or disabling Wake-On LAN
Prerequisite
A WOL-capable NIC, NIC driver, and operating system
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Server Availability > Wake-On LAN and press Enter.
2. Select a setting and press Enter.
a. Enabled
b. Disabled
3. Press F10.
POST F1 Prompt
Use this option to configure how the system displays the F1 key in the server POST screen. When enabled
and an error occurs, you can press the F1 key to continue with the server power-up sequence.
A series of system tests execute during POST and:
Wake-On LAN 109