HPE ProLiant Gen9

Configuring Storage Options
Storage Options
• Fibre Channel/FCoE Scan Policy
• Embedded Storage Boot Policy
• PCIe Storage Boot Policy
Fibre Channel/FCoE Scan Policy
Use this option to change the default policy for scanning for valid FC/FCoE (or boot from SAN) boot targets.
By default, each installed FC/FCoE adapter only scans targets that are preconfigured in the device settings.
NOTE:
This setting is only available in UEFI Boot Mode. For Fibre Channel controllers in PCIe slots, this setting is
overridden by the PCIe Storage Boot Policy setting.
Changing the default Fibre Channel/FCoE scanning policy
Prerequisite
Boot Mode is set to UEFI Mode.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > Fibre Channel/FCoE Scan Policy and press Enter.
2. Select a setting and press Enter.
a. Scan All Targets—Each installed FC/FCoE adapter scans all available targets.
b. Scan Configured Targets Only—Each installed FC/FCoE adapter only scans targets that are
preconfigured in the device settings. This setting overrides any individual device settings configured in
the device-specific setup.
3. Press F10.
Embedded Storage Boot Policy
Use this option to select the UEFI BIOS boot targets for embedded storage controllers. By default, all valid
boot targets attached to the storage controller are available to the UEFI Boot Order list.
Setting the embedded storage boot policy
Prerequisite
Boot Mode is set to UEFI Mode.
70 Configuring Storage Options