HPE ProLiant Gen9

a. Enabled—Generates the ACPI x2APIC control structures, and adds the option of enabling x2APIC
support to the operating system when it loads.
b. Disabled—Disables x2APIC support.
3. Press F10.
SATA Controller Options
• Embedded SATA Configuration
• SATA Secure Erase
Embedded SATA Configuration
Use this option to enable embedded chipset SATA (Serial Advanced Technology Attachment) controller
support. You can select AHCI or HPE Dynamic Smart Array RAID support. Make sure that you are using the
correct operating system drivers for your selected option.
CAUTION:
Dynamic Smart Array is not supported when the boot mode is configured to Legacy BIOS Mode.
Enabling Dynamic Smart Array RAID results in data loss or data corruption on existing SATA drives.
Back up all drives before enabling this option.
See your operating system documentation before enabling SATA AHCI support to ensure your base
media drivers support this feature.
Enabling embedded chipset SATA controller support
Prerequisites
• The correct operating system drivers for your selected option.
• Boot Mode is set to UEFI Mode.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > SATA Controller Options > Embedded SATA Configuration and press
Enter.
2. Ensure that you are using the correct ACHI or RAID system drivers for your SATA option.
3. Select a setting and press Enter.
a. Enable SATA AHCI Support—Enables the embedded chipset SATA controller for AHCI.
b. Enable Dynamic Smart Array RAID Support—Enables the embedded chipset SATA controller for
Dynamic Smart Array RAID.
4. Press F10.
SATA Controller Options 47