NOTE:
To use this setting:
â—¦ Configure the pre-boot network settings to access the URL location.
â—¦ Leave the boot mode set to UEFI Boot Mode.
When booting from an ISO file, use a file that the system can use to boot a preliminary operating system
environment, such as WinPE, mini-Linux, or VMware ESX installer. Doing so enables further installation to
proceed over an OS network connection. ISO files that contain the full OS installation media are not
supported.
Configuring Pre-Boot Network Settings
Prerequisites
When using the Boot from URL setting:
• Configure the pre-boot network settings to access the URL location.
• Leave the boot mode set to UEFI Mode.
• When booting from an ISO file, use a file that the system can use to boot a preliminary operating system
environment, such as WinPE, mini-Linux, or VMware ESX installer.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Network Options > Pre-Boot Network Settings and press Enter.
2. Select any of the Pre-boot Network Settings options and press Enter, then select a setting or enter a
value for that option and press Enter again.
iSCSI Boot Configuration
• iSCSI Initiator Name
• Add an iSCSI Boot Attempt
• Delete iSCSI Boot Attempts
• iSCSI Attempts
NOTE:
You can also configure iSCSI Boot settings using the RESTful Interface Tool. See the RESTful Interface Tool
documentation at: http://www.hpe.com/info/restfulinterface/docs.
iSCSI Initiator Name
Use this option to set a name for the iSCSI initiator using iSCSI Qualified Name (IQN) format. EUI format is
not supported. This option overrides the default name set for the initiator.
66 Configuring Pre-Boot Network Settings
To Next Page
Loading...
