HPE ProLiant Gen9

c. Physical Serial Port
d. Virtual Serial Port
3. Press F10.
4. If you enabled a BIOS serial console port, connect a null modem cable to the serial port/COM port on
which it is enabled.
BIOS Serial Console Emulation Mode
Use this option to select a serial console emulation mode type. Your selection depends on the emulation you
want to use in your serial terminal program (for example, Hyper Terminal or PuTTY). The BIOS emulation
mode must match the selected mode in the terminal program. When you select ANSI mode, some special
characters are displayed in the serial console (for example, a degree symbol °).
Setting the BIOS Serial Console Emulation Mode
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > BIOS Serial Console and EMS > BIOS Serial Console Emulation Mode and press Enter.
2. Select a setting and press Enter.
a. VT100
b. ANSI
c. VT100+
3. Press F10.
BIOS Serial Console Baud Rate
Use this option to set the transfer rate at which data is transmitted through the serial port.
Setting the BIOS serial console baud rate
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > BIOS Serial Console and EMS > BIOS Serial Console Baud Rate and press Enter.
2. Select a setting and press Enter.
a. 9600
b. 19200
c. 38400
114 BIOS Serial Console Emulation Mode