HPE ProLiant Gen9

Shell Auto-Start Script Location
Use this option to select the location of the Embedded UEFI Shell startup script. When UEFI Shell Script
Auto-Start is enabled, this setting specifies where the Shell looks for the startup.nsh file. When set to
Auto, the Shell looks for the script file in any of the FAT16 or FAT32 file systems available.
Setting the Embedded UEFI Shell startup script location
Prerequisites
• Boot Mode is set to UEFI Mode.
• Embedded UEFI Shell is enabled.
• UEFI Shell Script Auto-Start is enabled.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Embedded UEFI Shell > Shell Auto-Start Script Location and press Enter.
2. Select a setting and press Enter.
a. Auto—The Shell looks for the script file in any of the FAT16 or FAT32 file systems available.
b. File Systems on Attached Media—The Shell looks for the script file in a specific FAT16 or FAT32 file
system.
c. Network Location—The Shell looks for the script file at a specific URL.
3. Press F10.
Network Location for Shell Auto-Start Script
Use this option to set the network URL location of the UEFI Shell startup script.
• You can specify a URL in HTTP or FTP format using either an IPv4 server address or host name.
• The script file at the location must end with a .nsh file extension.
• When UEFI Shell Script Auto-Start is enabled, and the Shell Auto-Start Script Location is set to
Network Location, the Shell attempts to load and execute the startup script from the network location
pointed to by the specified URL.
NOTE:
IPv6 server addresses are not supported.
74 Shell Auto-Start Script Location