HPE ProLiant Gen9

Configuring Network Options
Procedure
1. From the System Utilities screen, select System Configuration > iLO 4 Configuration Utility >
Network Options, and press Enter.
2. Select any of the Network Options and press Enter, then select a setting or enter a value for that option
and press Enter again.
3. Press F10.
Advanced Network Options
• Gateway from DHCP—Specifies whether iLO uses a DHCP server-supplied gateway.
• Gateway #1, Gateway #2, and Gateway #3—If Gateway from DHCP is disabled, specifies up to three
iLO gateway IP addresses.
• DHCP Routes—Specifies whether iLO uses the DHCP server-supplied static routes.
• Route 1, Route 2, and Route 3—If DHCP Routes is disabled, specifies the iLO static route destination,
mask, and gateway addresses.
• DNS from DHCP—Specifies whether iLO uses the DHCP server-supplied DNS server list.
• DNS Server 1, DNS Server 2, DNS Server 3—If DNS from DHCP is disabled, specifies the primary,
secondary, and tertiary DNS servers.
• WINS from DHCP—Specifies whether iLO uses the DHCP server-supplied WINS server list.
• Register with WINS Server—Specifies whether iLO registers its name with a WINS server.
• WINS Server #1 and WINS Server #2—If WINS from DHCP is disabled, specifies the primary and
secondary WINS servers.
• Domain Name—The iLO domain name. If DHCP is not used, specifies a domain name.
Configuring Advanced Network Options
Procedure
1. From the System Utilities screen, select System Configuration > iLO 4 Configuration Utility >
Advanced Network Options, and press Enter.
2. Select any of the Advanced Network Options and press Enter, then select a setting or enter a value for
that option and press Enter again.
3. Press F10.
User Management
• Add User
• Edit/Remove User
Configuring Network Options 23