HPE ProLiant Gen9

The UEFI System Utilities are still open from the previous session.
b. Press Esc until the main menu is displayed.
c. Select Exit and Resume Boot in the main menu, and press Enter.
d. When prompted to confirm the request, press Enter to exit the utility and resume the normal boot
process.
About
Use this menu to view information about the following iLO components.
• Firmware Date—The iLO firmware revision date.
• Firmware Version—The iLO firmware version.
• iLO CPLD Version—The iLO complex programmable logic device version.
• Host CPLD Version—The server complex programmable logic device version.
• Serial Number—The iLO serial number.
• RBSU Date—The iLO 4 Configuration Utility revision date.
• PCI BUS—The PCI bus to which the iLO processer is attached.
• Device—The device number assigned to iLO in the PCI bus.
Viewing information about iLO
Procedure
1. From the System Utilities screen, select System Configuration > iLO 4 Configuration Utility > About,
and press Enter.
2. View information about iLO components.
Embedded device information
Smart Array Controller information
The System Configuration screens show device information about installed Smart Array Controllers. HPE
12 Gb/s capable SAS Smart Array controllers (for example, the Smart Array P44ar controller) support UEFI-
based servers.
NOTE:
Install only Smart Array Controllers that are listed as supported for your server and that are running the latest
versions of Smart Array Controller firmware. Other Smart Array controllers are not supported and might not
function properly in this server. Before installing the operating system, use the latest SPP in Offline mode to
upgrade the firmware to the latest version. Supported controllers not using the proper firmware display as an
unknown device in the system configuration.
28 About