Huawei TE20 - Page 88

TE20 Videoconferencing Endpoint
Administrator Guide
10 Security Maintenance
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
80
Parameter
Description
Setting
sends a session setup request to the ACS.
1800.
It is recommended that
this interval be shorter
than the timeout period
of the ACS. If this
interval is longer than
the timeout period, the
ACS may be
disconnected or the
session status may not
be updated in time after
a session setup timeout.
CPE User Name
Specifies the user name authenticated by
the endpoint after receiving a session setup
request from the ACS. The user name has
been specified on the ACS.
The default value is
admin.
CPE Password
Specifies the password authenticated by the
endpoint after receiving a session setup
request from the ACS. The password has
been specified on the ACS.
The default value is
Change_Me.
In addition, it must
include at least two of
the following: uppercase
letters, lowercase letters,
digits, and special
characters.
Authentication
mode
Specifies the mode in which the endpoint
will be authenticated when accessing to the
network management system.
The default value is
Digest.
If you set this parameter
to None or Basic, the
system will prompt you
that the authentication
mode poses security
risks. To ensure security,
set this parameter to
Digest.
The default value is
recommended.
STUN
Specifies whether to enable the Simple
Traversal of UDP through NAT (STUN)
function. If this function is enabled, the
endpoint can perform private-to-public
network traversal using the STUN server
on the TR-069 network.
NOTE
If you set this parameter to Enable, you must
also set STUN Server IP Address, STUN
Server Port, STUN listen port, STUN User
Name, STUN Password, and STUN keep-alive
period(s).
The default value is
Disable.
STUN Server IP
Specifies the IP address of the STUN
No default value is set