TE20 Videoconferencing Endpoint
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
To set the whitelist on the web interface, perform the following steps:
1. Choose System Settings > Whitelist.
2. Select Enable.
If Enable is deselected, the whitelist is invalid. That is, all IP addresses are allowed to
connect to the endpoint. You can modify the whitelist only after selecting Enable here.
3. Click Add and set IP address and Mask length.
4. Click OK. The settings take effect immediately.
If the endpoint is attacked and its web interface stops working, you can log in to the endpoint using the
serial port, enter the shell, and execute the iptables command to set the whitelist.
TR-069 Connection Credential and Account
The TR-069 server is connected to centrally manage endpoints.
To centrally manage endpoints on the TR-069 server, log in to the web interface, choose
System SettingsNetworkTR069, and set the TR-069 parameters listed in Table 10-2.
Table 10-2 TR-069 parameters
Specifies whether to enable the TR-069
function. If this function is enabled, the
endpoint will send a session setup request
to the Auto-Configuration Server (ACS).
Start the ACS before enabling the TR-069
function.
NOTE
If you set this parameter to Enable, you must
also set ACS User Name, ACS Password,
ACS Server IP Address, Report Interval(s),
CPE User Name, CPE Password, and
Authentication mode.
The default value is
Disable.
Specifies the user name authenticated by
the ACS after receiving a session setup
request from the endpoint. The user name
has been specified on the ACS.
No default value is set
for this parameter.
Specifies the password authenticated by the
ACS after receiving a session setup request
from the endpoint The password has been
specified on the ACS.
No default value is set
for this parameter.
Specifies the ACS URL, which can be
based on an IP address or domain name.
IP address-based URL example:
http://10.10.10.1:8086
Domain name-based URL example:
http://company.acs.com:8086 (8086
indicates the ACS port number)
No default value is set
for this parameter.
Specifies the interval at which the endpoint
To Next Page
Loading...
