c. Put the display in place (near the front of the machine).
d. Once the display is in place, secure it by tightening the screws «F¬.
3. Route the display power and signal cables through the top opening.
4. Reinstall the top cover «B¬ (see Figure 6-4 on page 6-3). Be sure that the signal
and power display cables are correctly routed in the top aperture «C¬. Secure
the top cover with the screws «A¬ previously removed.
5. At the rear of the Nways Switch administration station, connect the display
signal cable «L¬ (see Figure 6-8 on page 6-7).
D
D
F
Figure 6-7. Display Installation on Top of 29U Rack
6-6 2220 Setup and Service Guide
To Next Page
Loading...
