b. Plug one «T¬ connector (PN 80G0638) into the alarm and power control
(APC) card connector 4.
c. Route and plug the cable «B¬ (PN 10K8668) from the connector 6 of the
APC card into the Ethernet card connector «5¬.
d. Route and plug in the cable «C¬ (PN 80G0637) from the «T¬ connector
located on connector 4 of the APC card to the tailgate connector J2.
e. Plug the mouse cable «D¬ into the NAS connector «3¬.
f. Plug the keyboard cable «E¬ into the NAS connector «2¬.
g. Plug the power cable «F¬ into the NAS connector «6¬ of the NAS.
4. ____ Plug the power cords «F¬ and «G¬ into correctly grounded electrical
outlets.
Figure 1-2. NAS Cables Installation
Installing the NAS and Its Modem
Chapter 1. Installing and Configuring the NAS and Its Modem 1-3
To Next Page
Loading...
