1
Rear gear rack
locking
mechanism
2
Magnification of
rear gear rack
locking
mechanism
3
Front gear rack
Verify that the front (
3
in Figure 11-13) and rear (
1
in Figure 11-13) gear racks
are properly aligned and positioned.
v In a control module, verify that the gear racks are in the down position. Pinch
the gear rack locking mechanism (
2
in Figure 11-13) and push the gear rack
down. Ensure that the lock is not engaged in the hole in the frame.
v In an expansion module:
– Verify that the gear racks are in the down position. Pinch the gear rack
locking mechanism (
2
in Figure 11-13) and push the gear rack down. Ensure
that the lock is not engaged in the hole in the frame.
– Verify that there are no gaps in the gear racks between library units.
a66mi007
1
2
3
Figure 11-13. Gear rack
11-20 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
