IBM System Storage TS3310 User Manual

Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key ASC ASCQ Description Required Action
5 *3Bh *12h Media magazine not installed. **Library detected a missing magazine
during inventory.
Failure Isolation Procedure
No action is necessary. This is only a
status message.
5 *3Bh *A0h Media type does not match destination
media type.
6 3Fh 01h New firmware loaded Status changed.
Failure Isolation Procedure
No action is necessary. These are only
status messages.
4 3Fh 0Fh Echo buffer overwritten
4 40h 80h Component failure
B 43H 00H Message error A message could not be sent or received
due to excessive transmission errors.
Failure Isolation Procedure
If the problem persists, go to Fixing SCSI
Bus Problems.
4-B 44h 00h Firmware detected an internal logic
failure.
**
B 45h 00h Select or reselect failure Select or reselect failure
Failure Isolation Procedure
Review host error data to determine which
control path drive reported the error, then
isolate and repair the failing SCSI or Fibre
Channel component (go to Fixing SCSI
Bus Problems or Fixing SCSI Bus
Problems).
B 47h 00h SCSI parity error SCSI Parity error.
Failure Isolation Procedure
Review host error data to determine which
control path drive reported the error, then
isoalte and repair the failing SCSI or Fibre
Channel component (go to Fixing SCSI
Bus Problems or Fixing SCSI Bus
Problems).
B 48h 00h Initiator detected error message received. Initiator Detected Error message. a
command failed because the Initiator
Detected Error message was received by the
drive.
Failure Isolation Procedure
If the problem persists, go to Fixing SCSI
Bus Problems.
C-6 TS3310 Tape Library Setup and Operator Guide

IBM System Storage TS3310 Specifications

General

Model	TS3310
Type	Tape Library
Power Supply	Dual redundant power supplies
Tape Technology	LTO (Linear Tape-Open)
Humidity	20% to 80% non-condensing