Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key ASC ASCQ Description Required Action
6 2Ah 01h Mode parameters have been changed. **The Mode parameters for the drive have
been changed by an initiator other than the
one issuing the command. Mode Select
parameters were changed by another host,
or commands were cleared by another host.
Failure Isolation Procedure
No action is necessary. These are only
status messages.
6 2Ah 03h Reservations preempted.
6 2Ah 04h Reservations released.
6 2Ah 05h Registrations preempted.
5 2Ch 00h Command sequence error Command sequence error.
Failure Isolation Procedure
See “Contacting IBM Technical Support” on
page 9-15.
5 *30h *00h Incompatible medium installed Incompatible Media. A Write operation was
requested on a cartridge which is not
writable.
Failure Isolation Procedure
No action is necessary. This is only a
status message.
5 39h 00h Saving pararmeters not supported Saving Parameters is not supported.
Failure Isolation Procedure
No action is necessary. These messages
indicate that a host application sent an
invalid/unsupported command or multiple
hosts attempted to use a drive at the same
time.
4-5 3Bh 0Dh The destination element is full. The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See “Contacting IBM Technical Support” on
page 9-15.
4-5 3Bh 0Eh The source element is empty. The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See “Contacting IBM Technical Support” on
page 9-15.
Appendix C. Sense Data C-5
To Next Page
Loading...
Need help?
General
