S.68005 [S.68005]
Explanation: An error has been detected by the the IIO core logic on Bus %. The Global Fatal Error Status register
contains %. The Global Non-Fatal Error Status register contains %. Please check error logs for the presence of
additional downstream device error data. Critical IOH-PCI Error
Severity: Error
User response: Complete the following steps:
1. Check the log for a separate error related to an associated PCIe device and resolve that error.
2. Check the IBM support site for an applicable service bulletin or firmware update for the system or adapter that
applies to this error.
3. Replace the I/O device or PCIe adapter
4. (Trained technician only)Replace the system board reported in the error.
S.680B8 [S.680B8]
Explanation: Internal QPI Link Failure Detected. Internal QPI Link Failure Detected
Severity: Error
User response: Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Inspect the processor socket for foreign debris or damage. If debris is found, remove the debris.
3. (Trained technician only)If error recurs, or socket damage is found, replace the system board
4. (Trained Service Technician Only) Replace the processor.
S.680B9 [S.680B9]
Explanation: External QPI Link Failure Detected. External QPI Link Failure Detected
Severity: Error
User response: Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Inspect the processor socket for foreign debris or damage. If debris is found, remove the debris.
3. (Trained technician only)If error recurs, or socket damage is found, replace the system board
W.11004 [W.11004]
Explanation: A processor within the system has failed the BIST. Processor Self Test Failure Detected
Severity: Error
User response: Complete the following steps:
1. If the processor or firmware was just updated, check the IBM support site for an applicable service bulletin or
firmware update that applies to this processor error.
2. (Trained service technician only) If there are multiple Processor’s, swap Processor’s to move affected Processor to
another Processor socket and retry. If problem follows the affected Processor, or this is a single Processor
processor. Inspect the processor socket on each processor removal and replace system board first if the processor
socket is damaged or mis-aligned pins are found.
3. (Trained Service technician only) Inspect Processor socket on each Processor removal and replace system board
first if damaged or mis-aligned pins are found. Replace the system board.
S.68005 • W.11004
830
System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
Need help?
General
