W.3048006 [W.3048006]
Explanation: UEFI has booted from the backup flash bank due to an Automatic Boot Recovery (ABR) event.
Automated Boot Recovery, Booting Backup UEFI Image
Severity: Warning
User response: Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Update the primary UEFI image.
3. Replace the system board.
W.305000A [W.305000A]
Explanation: An invalid date and time have been detected. RTC Date and Time Incorrect
Severity: Warning
User response: Complete the following steps:
1. Check IMM/chassis event log. This event should immediately precede 0068002 error. Resolve that event or any
other battery related errors.
2. Use F1 Setup to reset date and time. If problem returns after a system reset, replace CMOS battery.
3. If problem persists then check IBM support site for an applicable service bulletin or firmware update that applies
to this error.
4. (Trained service technician only) Replace the system board.
W.3058009 [W.3058009]
Explanation: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings From F1. DRIVER
HEALTH PROTOCOL: Missing Configuration. Requires Change Settings From F1
Severity: Warning
User response: Complete the following steps:
1. Go to F1 Setup > System Settings > Settings > Driver Health Status List and find a driver/controller reporting
Configuration Required status.
2. Search for the driver menu from System Settings and change settings appropriately.
3. Save settings and restart system.
W.305800A [W.305800A]
Explanation: DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller. DRIVER HEALTH PROTOCOL:
Reports 'Failed' Status Controller
Severity: Warning
User response: Complete the following steps:
1. Reboot the system.
2. If problem persists, switch to backup UEFI or update the current UEFI image.
3. Replace the system board.
W.3048006 • W.305800A
Appendix B. UEFI/POST diagnostic codes 831
To Next Page
Loading...
Need help?
General
