W.3808000 [W.3808000]
Explanation: An IMM communication failure has occurred. IMM Communication Failure
Severity: Warning
User response: Complete the following steps:
1. Reset the IMM from the CMM.
2. Use the CMM to remove auxilliary power from the compute node. This will reboot the compute node.
3. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
4. Update the UEFI Firmware.
5. (Trained service technician only) Replace the system board.
W.3808002 [W.3808002]
Explanation: An error occurred while saving UEFI settings to the IMM. Error Updating System Configuration to
IMM
Severity: Warning
User response: Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxilliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
W.3808003 [W.3808003]
Explanation: Unable to retrieve the system configuration from the IMM. Error Retrieving System Configuration
from IMM
Severity: Warning
User response: Complete the following steps:
1. Use the Setup Utility to verify and save the settings (which will recover the settings).
2. Reset the IMM from the CMM.
3. Use CMM to remove auxilliary power from the compute node. This will reboot the compute node.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
5. Update the IMM Firmware.
6. Use CMOS clear jumper to clear CMOS
7. (Trained service technician only) Replace the system board.
W.3808000 • W.3808003
Appendix B. UEFI/POST diagnostic codes 833
To Next Page
Loading...
Need help?
General
