Table 7. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, Type 7377 server,” on page 125 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Message Severity Description Action
IP address of default
gateway modified from %1 to
%2 by user %3.
(%1 =
CIM_IPProtocolEndpoint.
GatewayIPv4Address;
%2 =
CIM_StaticIPAssignment
SettingData.Default
GatewayAddress;
%3 = user ID)
Info A user has modified the default
gateway IP address of the IMM.
No action; information only.
IP address of network
interface modified from %1
to %2 by user %3. (%1 =
CIM_IPProtocolEndpoint.
IPv4Address; %2 =
CIM_StaticIPAssignment
SettingData.IPAddress;
%3 = user ID)
Info A user has modified the IP address
of the IMM.
No action; information only.
IP subnet mask of network
interface modified from %1
to %2 by user %3. (%1 =
CIM_IPProtocolEndpoint.
SubnetMask; %2 =
CIM_StaticIPAssignment
SettingData.SubnetMask; %3
= user ID)
Info A user has modified the IP subnet
mask of the IMM.
No action; information only.
LAN: Ethernet[0] interface is
no longer active.
Info The IMM Ethernet interface has
been disabled.
No action; information only.
LAN: Ethernet[0] interface is
now active.
Info The IMM Ethernet interface has
been enabled.
No action; information only.
Memory DIMM Configuration
Error for All DIMMs on
Memory Subsystem All
DIMMs.
Error A DIMM configuration error has
occurred.
Make sure that DIMMs are installed
in the correct sequence and have
the same size, type, speed, and
technology (see “Installing a
memory module” on page 162).
Memory DIMM Configuration
Error for DIMM n Status on
Memory Subsystem DIMM
n Status.
(n = DIMM number)
Error A DIMM configuration error has
occurred.
Make sure that DIMMs are installed
in the correct sequence and have
the same size, type, speed, and
technology (see “Installing a
memory module” on page 162).
Memory DIMM Configuration
Error for One of the DIMMs
on Memory Subsystem One
of the DIMMs.
Error A DIMM configuration error has
occurred.
Make sure that DIMMs are installed
in the correct sequence and have
the same size, type, speed, and
technology (see “Installing a
memory module” on page 162).
100 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
