c. Press the interposer card down onto the interposer card connector so that
the interposer card is secured.
d. From the other side of the ServeRAID controller, insert and tighten the
screw to secure the interposer card to the ServeRAID controller.
3. Install the battery on the remote battery tray:
a. Press the retention latch to remove the remote battery tray from the PCI
riser-card assembly.
If you are installing a second ServeRAID controller battery, remove the
second remote battery tray from the power supply cage.
Chapter 5. Removing and replacing server components 173
To Next Page
Loading...
