Icom IC-7300 HF Plus User Manual

10-1
Section 10 SCANS
Scan types ............................................................................ 10-2
Preparation ........................................................................... 10-2
D Squelch status .............................................................. 10-2
Scan Set mode ..................................................................... 10-2
Programmed scan and Fine Programmed scan (VFO mode) .. 10-3
D Programmed scan operation ........................................ 10-3
D Fine Programmed scan operation ................................ 10-3
Memory scan and Select Memory scan (Memory mode) ..... 10-4
D Memory scan operation ................................................ 10-4
D Select Memory scan operation ..................................... 10-5
D Setting Select Memory channel .................................... 10-5
D Canceling all Select Memory channel settings ............. 10-5
∂F scan and Fine ∂F scan (VFO and Memory modes) ....... 10-6
D ∂F scan operation ........................................................ 10-6
D Fine ∂F scan operation ................................................ 10-6
Tone scan operation ............................................................. 10-7
Previous view

Icom IC-7300 HF Plus Specifications

General

Type	HF/50 MHz Transceiver
Modes	SSB, CW, RTTY, AM, FM
Receiver Type	Direct Sampling
Antenna Connector	SO-239
Antenna Impedance	50 ohms
Power Supply	13.8V DC ±15%
Frequency Coverage	0.030-74.800 MHz
RF Output Power	100 W
Receiver Sensitivity	0.15 μV (typical)
Receiver Selectivity	SSB: 2.4 kHz, CW: 500 Hz
Image Rejection Ratio	70 dB
IF Rejection Ratio	70 dB (HF bands), 60 dB (50 MHz band)
Audio Output Power	2.5 W (at 10% distortion)
Display	4.3-inch color TFT touch screen
Dimensions	240 x 94 x 238 mm
Number of Channels	101 (99 regular, 2 scan edge)
Current Consumption	21A (maximum transmission)