EasyManuals Logo

Icom IC-7300 HF Plus User Manual

Icom IC-7300 HF Plus
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
4
RECEIVING AND TRANSMITTING
4-7
IP Plus function
The IP Plus function improves the Intermodulation
Distortion (IMD) quality by exerting the direct sampling
system performance.
This function optimizes the Analog/Digital Converter
(ADC) against the distortion when you receive a
strong input signal. It also improves the Third-order
Intercept Point (IP3) while minimizing the reduction of
the receive sensitivity.
1. Push
FUNCTION
.
The FUNCTION screen is displayed.
2. Touch [IP+].
LTouch [IP+] to turn the IP Plus function ON or OFF.
L Select ON to prioritize the IP quality, and select OFF
to prioritize the receive sensitivity.
3. To close the FUNCTION screen, push
EXIT
.
“IP+” is displayed when ON is selected.
Displayed
SHARP
This selection is to emphasize the passband width of
the lter. The lter has an almost ideal shape factor.
Signals of the out of passband are extremely ltered
out and it gives you better audio quality.
SOFT
The lter shoulders are roundly formed as in analog
lters. This decreases noise components in the
high and low frequencies of the lter passband
and increases the S/N of the target signal. These
characteristics play an effective role in picking up
very weak signals in the 50 MHz band, for example.
The shape factor is kept, and the sharpness of the
bandpass is excellent.
Selecting the IF lter shape (Continued)
Previous view

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-7300 HF Plus and is the answer not in the manual?

Icom IC-7300 HF Plus Specifications

General IconGeneral
TypeHF/50 MHz Transceiver
ModesSSB, CW, RTTY, AM, FM
Receiver TypeDirect Sampling
Antenna ConnectorSO-239
Antenna Impedance50 ohms
Power Supply13.8V DC ±15%
Frequency Coverage0.030-74.800 MHz
RF Output Power100 W
Receiver Sensitivity0.15 μV (typical)
Receiver SelectivitySSB: 2.4 kHz, CW: 500 Hz
Image Rejection Ratio70 dB
IF Rejection Ratio70 dB (HF bands), 60 dB (50 MHz band)
Audio Output Power2.5 W (at 10% distortion)
Display4.3-inch color TFT touch screen
Dimensions240 x 94 x 238 mm
Number of Channels101 (99 regular, 2 scan edge)
Current Consumption21A (maximum transmission)

Related product manuals