Icom IC-7300 HF Plus - Adjusting Output Level and TX Settings

7
VOICE TX MEMORY OPERATION
7-5
Transmitting a Voice TX memory (Continue)
D Adjusting the output level
Adjusts the Transmit voice level.
1. Open the VOICE TX screen in a Voice mode.
L(Voice mode: SSB, AM or FM modes).
MENU
»
VOICE
2. Touch [TX LEVEL].
• Opens the “TX LEVEL” window.
3. Touch any desired Voice memory key other than
[T4] or [T8]. ([T1], [ T2], [T3], [T5], [T6] or [T7])
• The transceiver automatically transmits.
L To adjust the Transmit voice level using [T4] or [T8],
reverse steps 2 and 3 .
4. While transmitting, rotate
MAIN DIAL
to adjust the
transmit voice level.
L The transceiver automatically returns to receive
when all of the recorded content in the memory is
transmitted.
L Adjusting TX LEVEL too high may result in an over
modulation and transmit signal distortion.
5. To close the VOICE TX screen, push
EXIT
several
times.
Rotate
MAIN DIAL
Touch for 1 second to
reset to the default setting
TIP: How to cancel a Voice TX transmission
• Touch any keys other than [TX LEVEL] on the VOICE
TX screen
• Push
EXIT
,
V/M
,
▲
, or
▼
• Touch the frequency’s MHz digits or the Memory
channel number
• Turn OFF the transceiver
Previous view