Icom IC-i7410 - D Contest Number Set Mode

41
4
RECEIVE AND TRANSMIT
■ Electronic keyer functions (continued)
D Contest number Set mode
This mode is used to set the contest number and count
up trigger, etc.
• Setting contents
q In the CW mode, p ush [MENU] to display the “M1”
screen (Menu 1).
w Push [KEY](F-4) to display the “KEY” screen (Mem-
ory Keyer).
e Push [001](F-4) to enter the Contest Number Set
mode.
r Push [Y](F-1) or [Z](F-2) to select the desired
item.
t Rotate [DIAL] to select the desired option.
 •Holddown[F-3]for1secondtoresettothedefaultset-
ting, if desired.
y Push [MENU] to save, and return to the “KEY”
screen.
u Push [MENU] again to return to the “M1” screen.
Number Style 1. (Default: Normal)
This item sets the numbering system used for contest
numbers— normal or short morse numbers.
Short morse numbers are also referred to as “cut”
numbers.
•Normal :Doesnotuseshortmorsenumbers
•190➔ANO : Sets 1 as A, 9 as N and 0 as O.
•190➔ANT : Sets 1 as A, 9 as N and 0 as T.
•90➔ NO : Sets 9 as N and 0 as O.
•90➔ NT : Sets 9 as N and 0 as T.
Count Up Trigger 2. (Default: M2)
Set the count-up trigger to one of four memory slots
for the contest number exchange. The count-up trigger
allows the contest number to automatically advance
after each complete serial number exchange is sent.
•M1,M2,M3orM4canbeset.
Present Number 3. (Default: 001)
This item shows the current number for the count-up
trigger channel set above.
•Rotate[DIAL]tochangethenumber,orholddown
[F-3](CLR) for 1 second to reset the current number
to 001.
∫
1
√
Normal
001
Number Style
Select the item Reset to the default
setting