Icom IC-i7410 - Set Mode; Set Mode Description

78
SCANS
1
2
3
4
5
6
7
9
10
12
13
14
15
16
17
18
19
20
21
11
8
8
A programmed scan searches for signals between
Program Scan Edge channels “P1” and “P2.”
Before starting the programmed scan, scan edges
must be programmed into these channels.
Refer to “■ Memory Channel programming” to pro-
gram Program Scan Edge channels. (p. 70)
If the same frequencies are programmed into the
Program Scan Edge channels, the programmed
scan will not start.
q Push [VFO/MEMO] to select the VFO mode.
w Push a mode switch to select the desired operating
mode (p. ).
 •Theoperatingmodecanalsobechangedwhilescan-
ning.
e Push [TS] one or more times to select a tuning step.
(p. 27)
 •Thetuningstepcanalsobechangedwhilescanning.
r P ush [MENU] once or twice to display the “M2”
screen (Menu 2).
t P ush [SCAN](F-1) to display the “SCAN” screen.
y Rotate the [RF/SQL] control to set the squelch to
open or closed.
 •Thescanperformancediffers,dependingonthesquelch
setting when the scan was started. See page 76 for de-
tails.
 •Ifthe[RF/SQL]controlfunctionissetto“AUTO,”the
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
u Push [PRO](F-1) to start or cancel the programmed
scan.
 •TheMHzandkHzdecimalpoints,and“PROGSCAN”
blink while scanning.
 •Rotating[DIAL]alsocancelsthescan.
■ Programmed scan/Fine programmed scan (VFO mode)
D About the Fine programmed scan
When a signal is received during Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q Start the programmed scan.
 •Followstepsq through u as described above.
w While scanning, push [FIN](F-3) to switch the scan
function between a programmed scan and a Fine
programmed scan.
 •“F-PROGSCAN”blinkswhileFineprogrammedscan-
ning.
e Push [PRO](F-1) to cancel the scan.
 •Rotating[DIAL]alsocancelsthescan.
[SCAN]/[PRO] [VFO/MEMO] [TS]
[MENU][RF/SQL] Mode switches
While Programmed scanning
PRO
∂ F
SPAN SETFIN
SCAN
∂ F : ± 10k
PRO
∂ F
SPAN SETFIN
SCAN
PROG SCAN
PRO
∂ F
SPAN SETFIN
SCAN
PROG SCAN
PRO
∂ F
SPAN SETFIN
SCAN
F−PROG SCAN
While Fine programmed scanning