WSB-9454 CPU Card
Page 110
On-board Floppy Controller [Enabled]
Use the On-board Floppy Controller to enable or disable the floppy controller. If a floppy
disk is not being used in the system, disabling this option frees up system resources that
can be redirected elsewhere in the system.
Disabled
Allows BIOS to disable the floppy controller
Enabled
D
EFAULT Allows BIOS to enable the floppy controller
Serial Port1 Address [3F8/IRQ4]
The Serial Port1 Address option allows BIOS to select the Serial Port 1 base address.
Disabled
No base address is assigned to Serial Port 1
3F8/IRQ4
D
EFAULT Serial Port 1 I/O port address is 3F8 and the interrupt
address is IRQ4
3E8/IRQ4
Serial Port 1 I/O port address is 3E8 and the interrupt
address is IRQ4
2E8/IRQ3
Serial Port 1 I/O port address is 2E8 and the interrupt
address is IRQ3
To Next Page
Loading...
Need help?
General
