WSB-9454 CPU Card
Page 69
Wear an electrostatic discharge cuff (ESD)
o Electronic components are easily damaged by ESD. Wearing an ESD cuff
will remove ESD from your body and help to prevent ESD damage to the
CPU card.
Place the CPU Card on an antistatic pad
o When you are installing or configuring the CPU Card, place it on an
antistatic pad. This will help to prevent potential ESD damage.
Turn off all power to the WSB-9454 CPU card
o When working with the CPU card, make sure that it is disconnected from
all power supplies and that no electricity is being fed into the system.
Before and during the installation of the WSB-9454 CPU card DO NOT:
remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
use the product before you have verified that all cables and power connectors
are properly connected.
allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 Unpacking
NOTE:
If any of the items listed below are missing when you unpack the
WSB-9454 CPU card, do not proceed with the installation and contact the
reseller or vendor you purchased the CPU card from.
4.3.1 Unpacking Precautions
Before you install the WSB-9454 CPU card, you must unpack the CPU card. Some
components on WSB-9454 are very sensitive to static electricity and can be damaged by a
sudden rush of power. To protect it from being damage, follow these precautions:
To Next Page
Loading...
Need help?
General
