WSB-9454 CPU Card
Page 82
4.5.4.1 IDE Drive Connector (PIDE1)
The cable used to connect the motherboard to the IDE device is a standard 40-pin
ATA/100 flat cable. To connect an IDE device to the motherboard, follow the instructions
below.
Step 1: Find the IDE flat cable in the kit that came with the motherboard.
Step 2: Connect one end of the cable to the IDE connector on the motherboard. A keyed
pin on the IDE connector prevents it from being connected incorrectly.
Step 3: Locate the red wire on the other side of the cable that corresponds to the pin 1
connector.
Step 4: Connect the other side of the cable to the IDE device making sure that the pin 1
cable corresponds to pin 1 on the connector.Step 0:
To Next Page
Loading...
Need help?
General
