49
2
INSTALLATION PROCEDURE
302.061
ERROR CAUSE CURE
After the selector switch on the
remote control panel has been tur-
ned to the “AUTOMATIC” position,
this message appears.
The “MANUAL” mode was actuated
from the keyboard on the bar fee-
der.
To actuate the “AUTOMATIC” mode
press the push-button on
the bar feeder keyboard.
CAUSE CURE
No value was set at
parameter 40
. Enter the values in the subparameters.
ERROR CAUSE SOLUTION
During the 1st feeding stroke the
short feed control gate detected a
bar which is too long.
The bar exceeds the maximum loa-
dable length of bars.
Load bars of the maximum length
allowed, which corresponds to the
maximum length inside the lathe
spindle.
32
Er ror :Manua l f rom ke
yboard
33
(Error: sub- spindl e p
arameters wrong
34
(Error: . . . )
35
Error :bar too l ong
To Next Page