50
2
INSTALLATION PROCEDURE
302.061
ERROR CAUSE SOLUTION
The bar feeder does not actuate the
function.
The bar reached the facing position,
but the lathe did not restart.
Check the K15 interface signal:
"Cycle Start".
Check the lathe.
CAUSE SOLUTION
When the operator presses the AUTOMATIC push-but-
ton to actuate a bar change, the FEEDING signal is not
received.
Check the corresponding interface signal.
Open the collet.
36
Er ror : f ac i ng t imeout
37
(Error: . . . )
38
(Error: . . . )
39
Error:col let not ope
n
To Next Page