Intel Core 2 Duo Processor User Manual

Getting Started
24 Development Kit User’s Manual
12. From DOS, run the following to reprogram the MAC address and make sure that
there are no warnings or errors:
• eeupdate /nic=1 /mac=xxxxxxxxxxxx
(xxxxxxxxxxxx is the MAC Address from the sticker)
13. From DOS, run the following to update the keyboard and system controller flash
and make sure that there are no warnings or errors:
• kscupdate ksc.bin
14. Power the system down by pressing the PWR button.
15. Clear the CMOS by performing the following:
h) Shunt the CMOS CLR jumper (J5H2 – near the on-board battery).
i) Press the PWR button on the board. The board will not power on, but a couple
of LEDs will flash.
j) Switch the power supply off to power down the board.
k) Remove the CMOS CLR jumper (J5H2).
16. Unplug the bootable USB key.
17. Verify correct BIOS installation:
a) Switch the power supply back on.
b) Press the PWR button on the board to power up the system.
c) Boot to the BIOS Configuration screen by pressing F2 at the BIOS splash
screen.
d) In the BIOS main screen, check that the “Project Version” lists the correct
version of the BIOS.
e) Press the PWR key on the board to power the system back down.
18. Re-connect the SATA data cable from the hard drive to the development
board at connector J6J3.
The system is now ready for normal operation.
§

Intel Core 2 Duo Processor Specifications

General

Number of Cores	2
Manufacturing Process	65nm or 45nm (depending on model)
Execute Disable Bit	Yes
Enhanced Intel SpeedStep Technology	Yes
L2 Cache	2MB, 4MB, or 6MB (depending on model)
Front Side Bus	1066 MHz
Thermal Design Power (TDP)	35W - 65W (depending on model)
Socket Type	LGA775
Clock Speed	1.6 GHz - 3.33 GHz (depending on model)
Instruction Set	x86, x86-64
Virtualization Technology	Yes (depending on model)
Architecture	Intel Core Microarchitecture