Intel FALCON 8 Plus

USER MANUAL
INTEL® FALCON™ 8+ UAS
© 2017 Intel Corporation. All rights reserved 147
Selecting
Falcon
Info
and pushing
ENT opens an
information
screen.
Here you see
the serial num-
ber and the
firmware ver-
sions of the
current hard-
ware compo-
nents. In the
last column,
the activated
feature pack-
ages are
shown.
Further details
are found in
see “Checking
Activated Soft-
ware Feature
Packages” on
page 63. Push-
ing ESC brings
you back to
the menu.
Selecting
Video Bind
and pushing
ENT estab-
lishes (again)
the video con-
nection
between the
UAV and the
CTR.
Selecting
Volume
and pushing
ENT high-
lights the
number
behind.
By pushing the
RIGHT/LEFT
arrow buttons
you can mod-
ify the volume
of the audible
messages of
the Status Dis-
play of the
CTR.
A range from
10 (low vol-
ume) to 100
(high volume)
is available.
Pushing ENT
confirms the
selection.
Pushing ESC
brings you
back to the
menu.
see “Intel® Cockpit Controller
(CTR) Overview” on page 24
Selecting
Language
and pushing
ENT high-
lights the field
to the right.
By pushing the
RIGHT/LEFT
arrow buttons
you can select
between
English (ENG)
and German
(
GER). Push-
ing ENT con-
firms and
pushing ESC
brings you
back to the
menu.
Selecting
Def.
Params
and pushing
ENT opens a
special screen.
This function
is only for ser-
vice personal.
Selecting
Service
Fcts.
and pushing
ENT opens a
special screen.
This function
is only for ser-
vice personal.
For Compass
Calib.
and
Payload
Calib.
see
“Payload and
Compass Cali-
bration” on
page 34
Table 4.1: Status Display Menu Structure (Continued)